Changzhou Jinsanshi Mechatronics Co., Ltd
Changzhou Jinsanshi Mechatronics Co., Ltd
Add to Cart
Brushless Dc Driver 12-56VDC PWM Control Max 15A 300W 24v 440w 48v
Brushless dc driver:
Features:
Acceleration/deceleration time setting
Motor pole number setting
Maximun current output setting
Open/closed loop control
Motor torque holding
Restart
Various alarm indications
Internal potentiometer and RV speed control
External analog signal speed regulation
PWM speed control
We are a comprehensive company which specializes in producing and researching stepper motor and motor driver, closed loop stepper motor, step servo motor, brushless dc motor, brushless dc driver, spindle motor. Our company is located in Changzhou city, Jiangsu province, China. We have an excellent group with rich experience in manufacturing and researching. We can solve the actual using problems for customers. Our products are highly commended by customers because of its easy operation, long using life, stable performance, low failure rate and high technical content.
Electrical parameters:
| Parameter | Min | Rated | Max | Unit |
| Motor Hall angle | 120°/240° | |||
| DC input voltage | 12 | 48 | 56 | V |
| Driving current output | - | - | 15 | A |
| Applicable motor speed | - | - | 20000 | rpm |
| Hall signal voltage | - | - | 5 | V |
| Hall signal current | 12 | - | - | mA |
| External potentiometer | 10 | KΩ | ||
Environment paramaters:
| Cooling | Natural cooling or Forced cooling |
| Using Occasion | Avoid dust, oil and corrosive gas |
| Using temperature | 10℃-+50℃ |
| Environment Humidity | 90%RH(No condensation) |
| Vibration | 5.7m/S2max |
| Storage temperature | 0℃-+50℃ |
Connection definitions:
| Flag definitions | |
| DC + / DC- | DC power entry (DC12V ~ DC56V) positive and negative do not reversed |
| U, V, W | motor leads (thick line connected U, V, W) |
| Hu, Hv, Hw | Hall signal line (thin pick Hu, Hv, Hw) |
| REF + | Hall positive power supply (power supply to the motor Hall + 5V) |
| REF- | Hall negative power supply - (Hall ground connected to this port) |
| VCC | power port external potentiometer (not to other external circuitry, can only do potentiometer power use) |
| SV | external potentiometer terminals, External analog voltage input, PWM speed control signal input |
| COM | Public port (0V reference level) |
| F / R | directions: Leave or high forward and low reverse |
| EN | Enable: High / Low stop / run |
| BRK | fast brakes: High / Low stop / run |
| SPEED | Corresponding to the running speed of the motor, the corresponding pulse frequency is output. Use SPEED-OUT to calculate the speed of the motor. The calculation formula is: N(RPM)=(F/P)*60/3 |
| ALM | Motor or drive control fault signal output is usually 5V, when a fault occurs, the level is 0V |
Dimensions:
